dji A3 User Manual

A3/A3Pro
User Manual
©
2016 DJI. All Rights Reserved.
9
The arrow directions in the above diagram indicate the rotation direction of the motor/
propeller. Dark colored arm (s) indicate the direction of the aircraft’s nose.
For coaxial propellers, dark colored propellers are at the top and gray colored propellers
are at the bottom. Otherwise, all propellers are at the top.
B. Remote Controller System
The following remote controller systems are supported. Whatever type of receiver is used,
please make sure that the receiver and remote controller are linked properly before use. Be
sure to link the receiver and remote controller according by following all the procedures in
the remote controller and receiver user manual, and according to the congurations in DJI
Assistant 2.
DJI Lightbridge 2
DJI Lightbridge 2 lets you use DJI GO to congure the ight control system parameters and
utilize Intelligent Flight Modes.
DR16
The DR16 receiver does not support the Point of Interest (POI) and Waypoint ight modes in
DJI GO.
S-Bus
The S-BUS receiver does not support the Point of Interest (POI) and Waypoint ight modes
DJI GO.
There is no need to enable the Failsafe function on the remote controller. Once the
receiver loses signal from the remote controller, the controller unit will enter Failsafe
mode automatically, and the aircraft will hover or return-to-home & land according to
the Failsafe congurations in DJI Assistant 2.
C. ESC
ESC output should be 400Hz. DJI Propulsion systems are recommended.
The iESC port can connect to the DATA port if using the DJI Intelligent ESC.
D. Battery
Both the 3S-12S LiPo battery and the DJI Intelligent Flight Battery are supported.
The DJI Intelligent Flight Battery provides voltage, battery level and battery cell information, as
well as low battery level protection.
If using a LiPo battery, only the voltage information and low voltage protection are available.
The S900 and DJI Lightbridge 2 are recommended for the A3 series, and are used as
examples in this manual.

dji A3 Specifications

Flight Performance

hovering accuracy (vertical)	±0.5 m
hovering accuracy (horizontal)	±2 m
max wind resistance	10 m/s
max yaw angular velocity	150°/s
max pitch angle	35°
max ascent velocity	6 m/s
max descent velocity	6 m/s

Power and Environment

power consumption	Max 21 W (Typical Value: 0.41 A @ 51 V)
operating temperature	14° to 113° F (-10° to 45° C)