-1-
A
B
NORMAL MODE
LIMITLESS 5
®
Quick Start Guide
To learn more about drones before flying, head to our website
www.DroneCloneXperts.com
where you’ll find videos, manuals, and other great instructional resources.
2. Syncing Remote Control with Drone
4. Drone Gyroscope and Gimbal Level Calibration
3.
Drone placed horizontal
Remote control
Power ON Button
figure 1 figure 2 figure 3
Long press this key
for 5 seconds
Long press this key
for 5 seconds
1. Precautions for Using the 3-Axis Gimbal Camera:
IMPORTANT NOTE:
A. Remove the protective cover from the camera before turning on!
B. Do not touch the gimbal camera during start-up of this product!
Reason: As soon as drone is powered on, the gimbal automatically
calibrates itself. If you touch it during this process, the gimbal will fail
to calibrate properly, and it could potentially damage the gimbal!
You must first calibrate the drone. Watch demonstration
video at DroneCloneXperts.com for easy instructions.
This is also known as “correcting geomagnetism and
then the gyroscope”. If ignored, it will affect normal use.
Important Tip:
!
FIRST, turn the DRONE on.
NEXT, turn the REMOTE on (Be sure to always follow this sequence).
After the remote control of the drone is powered on, wait for about one minute for the
drone and remote to sync to each other.
Note: The drone must be placed on flat ground directly in front of the remote controller,
and the remote controller makes a "beep" after the frequency is successfully connected,
and the drone and the remote controller are successfully linked.
Place the drone on a horizontal surface.
Then press & hold PHOTO CAMERA
button on top-left of remote control for 5
seconds (figure 4) until you hear a beep.
The drone lights will initially flash quickly
and then change to solid lights when
calibration is completed. Do not touch or
*Please ensure the drone and remote control batteries are fully charged before every flight.
Geomagnetic Calibration *(Please watch our instruction video for quick & easy demonstration)*
move the drone during this process
UNTIL the lights STOP flashing rapidly.
Drone Power
ON / OFF
Short press
immediately
followed by long
press
figure 4
Place drone on a horizontal surface while drone power is ON. Press and Hold VIDEO CAMERA button (Figure 1) for 5 seconds to perform
geomagnetic correction. At this time, the aircraft lights flash quickly. Pick up the drone and (Figure 2) rotate horizontally 3x clockwise
(see our
instructional video for quick & easy demonstration)
. Don’t stop rotating until you hear a beep. Once beep sounds, then hold drone with camera
facing the ground (Figure 3) and rotate 3-5x clockwise. The remote control emits a beep when finished and the drone lights flash slowly.
Geomagnetic correction is now complete! This can be hard to mimic from text instructions, so we encourage users to watch our demo video!
**Wether you rotate the drone clockwise or counter-clockwise does NOT matter! Just be sure to use the same direction for both
horizontal and vertical rotations**
Drone-Clone Xperts
DO NOT touch the camera while the drone is on, ESPECIALLY
during gimbal calibration!
To Next Page
Loading...
Need help?
General
