-14-
B
A
A
B
1
2
3
1. Propeller Installation & Replacement [VERY IMPORTANT]
Battery Installation
2. Aircraft Lithium Battery
1. Battery Power Button
2. Battery Level Indicator
3. USB Charging Port
Battery
Power
LOW
HIGH
– Gently push the battery down into the drone as
shown.
–After the installation is complete, the battery clips on
both sides will pop up, at which time you should check
to confirm the battery is securely locked in place.
!
REMINDER: If the battery is not installed properly, it is likely to cause an interuption in power, which can lead to major accidents.
After the drone is used, please turn off battery power and remove it from the drone. Stroe the battery in a cool / dry place to prevent
battery damage from the heat eminating from the drone’s motors after flight.
Note: If the drone does not take off for more than 10 minutes after it is powered on, the battery will start an automated protection
program and power off by itself! This is a newly added safety feature and is completely normal.
IMPORTANT: Make sure all propellers are installed in the correct orientation as shown in the figure below. If the installation is incorrect, the
aircraft will NOT fly normally and will likely crash.
All propellers are labeled with either the letter ‘A’ or letter ‘B’ and must match the
cooresponding arms/legs labeled with the same letter. SEE VIDEO on
DroneCloneXperts.com if you are unsure.
-To turn the drone ON once the battery is installed, give 1 quick short press of the power button, immediately followed by
a long press & hold of the power button for 3 seconds. A series of BEEPS will sound & lights will flash as the drone turns
ON.
-When only one light shows on the battery power indicator, this indicates very low battery power. Please charge the
battery immediately to avoid damage caused by excessive discharge of the battery.
Turn Battery Power ON
To Next Page
Loading...
Need help?
General
