Chapter 2
3. To go back to the Ready state press [#].
NOTE: If your system has PIR cameras enrolled, two images from each PIR camera are sent to the mon-
itoring station during a system test.
2.5 Monitoring
This system is capable of transmitting alarms, troubles and emergency information. If you initiate an
alarm by mistake, immediately call the central station to prevent an unnecessary response.
NOTE: For CP-01 systems, the monitoring function must be enabled by the installer before it becomes
functional. There is a communicator delay of 30 seconds in this control panel. It can be removed, or it can
be increased up to 45 seconds, at the option of the end-user by consulting with the installer.
2.6 Maintenance
With normal use, the system requires minimum maintenance. Note the following points:
l Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened cloth
should remove normal accumulations of dust.
l Use the system test described in “Testing Your System” to check the battery condition. We recom-
mend, however, that the standby batteries be replaced every 3-5 years.
l For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave
motion detectors or glassbreak detectors, consult the manufacturer’s literature for testing and
maintenance instructions.
- 7 -
To Next Page
Loading...
Need help?
General
