dynabook C50-J-12A Instructions

Installing the LCD Module Assembly
Install the LCD Module Assembly according to the following procedures and Figure 4- 17and 4-
18.
1. Place the LCD Module Assembly in the correct position.
2. Secure LCD Module Assembly with four M2.0x5.5x4.5 black Phillips head
screws. (▲ mark portions)
3. Close LCD Module Assembly.
4. Note the module definition :grey wire connects MAIN interface and black wire connects AUX
5. Routing antenna cables under Rib on Top cover to secure antenna cables according to
Figure 4-18.
6. Put the PC gasket back on the WiFi module Install plastic chips on wifi module.
7. Connect LCD cable to CN6 on system board.
8. Routing LCD cable according to Figure 4-18, need to under Rib on Top Cover.
9. Stick tape to fasten LCD cable.

dynabook C50-J-12A Specifications

General

Brand	dynabook
Model	C50-J-12A
Category	Laptop
Language	English