Starting Hibernation Mode
To enter Hibernation Mode, click Start ->
(Power) and then select
Hibernate.
To show Hibernate in Power menu, set up according to the following
steps:
1. Click Start -> Windows System -> Control Panel -> System and
Security -> Power Options.
2. Click Choose what the power buttons do or
Choose what closing
the lid does.
3. Click Change settings that are currently unavailable.
4. Select the Hibernate check box from Shutdown settings.
5. Click the Save changes button.
Automatic Hibernation Mode
The computer can be configured to enter Hibernation Mode automatically
when you press the power button or close the lid. To define these settings,
do the following:
1. Click Power Options and then click Choose what the power
buttons do or Choose what closing the lid does.
2. Enable the desired Hibernation Mode settings for When I press the
power button and When I close the lid.
3. Click the Save changes button.
Data save in Hibernation Mode
When you turn off the power in Hibernation Mode, the computer takes a
moment to save the current data in memory to the internal storage.
After you turn off the computer, and the content of memory has been saved
to the internal storage, turn off the power to any peripheral devices.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
System Recovery
There is a hidden partition allocated on the internal storage for the System
Recovery Options in the event of a problem.
You can also create recovery media and restore the system.
The following items are described in this section:
Creating Recovery Media
Restoring the pre-installed software from your created Recovery
Media
User's Manual 2-19
To Next Page
Loading...
Need help?
General