Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved. Revision: 001
Document ID: 614-01975-00
19 (133)
3 Introduction to Eaton UPS
The Eaton 93E 15-80 kVA uninterruptible power supply (UPS) is a true
online, continuous-duty, transformer-free, double-conversion, solid-state,
3-phase system that provides conditioned and uninterruptible AC power
to protect the loads connected to it from power failures.
The Eaton 93E 15-80 kVA online power protection system is used to
prevent loss of valuable electronic information, minimise equipment
downtime, and minimise the adverse effect on production equipment
due to unexpected power problems.
The Eaton 93E 15-80 kVA UPS continually monitors incoming electrical
power and removes the surges, spikes, sags, and other irregularities that
are inherent in commercial utility power. Working with a building's
electrical system, the UPS system supplies clean, consistent power that
sensitive electronic equipment requires for reliable operation. During
brownouts, blackouts, and other power anomalies, batteries provide
emergency power to safeguard operation of the load equipment.
The UPS is housed in a single free-standing cabinet, with safety shields
behind the door for hazardous voltage protection.
This manual is for Eaton 93E series UPS, refer Section 10.1 for product
models.
Figure 1 shows the Eaton 93E 15-80 kVA UPS.
NOTE: Start-up and operational checks must be performed by a qualified
service personnel authorized by Eaton. If these instructions are not
followed, the warranty terms specified in Chapter 11 become void. This
service is offered as a part of the sales contract for the UPS. Contact
Eaton service representative in advance to reserve a preferred startup
date.
To Next Page
Loading...
Need help?
General
