Eaton FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide S 164201403 Rev B
www.eaton.com/powerquality
1
Chapter 1 Introduction
The Eaton
®
FERRUPS
®
uninterruptible power system (UPS) is available in
plug-receptacle or hardwired models. The plug-receptacle models have
an input plug and receptacles on the rear panel. The hardwired models
have terminal strips that an electrician has to wire to AC input.
See the following sections for steps on how to use this manual for your
UPS installation.
Plug-Receptacle Installation
Only a few sections in this manual are required for installing
plug-receptacle models:
S Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
S Complete Chapter 3, “Setup” for sett up the location of the UPS.
S If you purchased an external battery cabinet, an electrician must wire
the battery to the UPS as described in Chapter 7, “External Battery
Cabinet Installation.”
S Continue to the startup section in the Eaton FERRUPS FE/QFE UPS
(500 VA–18 kVA) User's Guide.
Hardwired Installation
Most of the sections in this manual are required for the electrician to
install the hardwired models:
S Be sure to read all safety warnings before installing the UPS as stated
in Chapter 2, “Safety Warnings.”
S Complete Chapter 3, “Setup” for setting up the location of the UPS.
S Chapter 4, “Electrical Installation” describes the electrical
requirements for hardwiring the UPS.
S Continue to either Chapter 5, “External Bypass Switch Installation” or
Chapter 6, “Internal Bypass Switch Installation” depending on the the
type of bypass switch being installed.
To Next Page
Loading...
Need help?
General