Eaton Network Management Card User Manual

Network Management Card
– User Manual 34003991XT_EN/EF Page 80/127
• Shutdown timer selected
• Shutdown duration
• Battery capacity exceeds
• Outlet 2 & 3:
• Name
• Switch off after
• Remaining capacity limit
• Shutdown duration
• Switch on after
6.2.6 SNMP settings
These settings configure the 2 SNMP versions available, v1 and v3.
The parameter list is the following:
• Version
• SNMP v1 community Read-Only
• SNMP v1 write enables
• SNMP v1 community write
• SNMP v3 user Read-Only
• SNMP v3 security Read-Only
• SNMP v3 password Read-Only
• SNMP v3 user Read-Write
• SNMP v3 security Read- Write
• SNMP v3 password Read- Write
• Notification user name
6.2.7 Date and time
These settings enable the initialisation of the date and time of the card in three different ways.
The parameter list is the following:
• Date & Time
• Type of synchronisation
• NTP host name
• Time-Zone
• Daylight saving time
6.2.8 Environment settings
These settings enable the configuration of the environment sensor. If not present, this menu is not available.
The parameter list is the following:
• Sensor name
• Temperature:
• Unity

Eaton Network Management Card Specifications

General

Model	Network Management Card
Operating Temperature	0°C to 40°C (32°F to 104°F)
Network Protocols	TCP/IP, HTTP, HTTPS, SNMP, SMTP, Telnet, SSH
Management Interface	Web-based, CLI
Security	SSH
Firmware Upgrade	Remote firmware upgrade
Event Logging	Yes
Environmental Monitoring	Optional environmental sensor support
Communication Interface	Ethernet (10/100Base-T)
Remote Monitoring	Yes
Remote Control	Yes
Alerting	Email, SNMP traps
Management Features	Automated shutdown
Power Requirements	Powered by connected UPS
Humidity	95% non-condensing