EasyManuals Logo
Home>Ecolink>Thermostat>Z-Wave TBZ500

Ecolink Z-Wave TBZ500 User Manual

Ecolink Z-Wave TBZ500
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
24-02-2021 18:55
17
Feature
Description
Range
Default
Setting
Cooling Stage 1
Off Threshold
Sets the delta from setpoint that stage 1 cooling stops. Stage 1 turns off at
setpoint - Delta Stage 1
0 to 6 degrees
0
Cooling Stage 2
On Threshold
Sets the delta from setpoint that stage 2 cooling starts.
2 to 8 degrees 2
Restore Defaults Restores all settings to factory defaults. Press Yes to restore defaults
Press No to exit and not restore defaults
Y or N
N
Factory Default
Please use this procedure only when the Z-Wave Primary Controller is missing or otherwise inoperable. To reset the
TBZ500’s Z-Wave parameters to Factory Settings (both Z-Wave and HVAC settings):
1.
Remove power from the TBZ500.
2.
Restore power to the TBZ500.
3.
When “TBZ500” appears on the screen, hold down the MODE and FAN buttons at the same time.
4.
Release the buttons when RESET appears on the Status Line.
5.
Once the TBZ500 resets the Z-Wave and HVAC settings, a DONE confirmation message will appear on the screen before the thermostat self-reboots.
Copyright © Ecolink Intelligent Technology
TBZ500_manual_8_5x5_5_inch Combined_RDN1240221.indd 17
Cooling Stage 2
Off Threshold
Sets the delta from setpoint that stage 2 cooling stops.
Stage 2 turns off at setpoint - Delta Stage 2.
0 to 7 degrees
0

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ecolink Z-Wave TBZ500 and is the answer not in the manual?

Ecolink Z-Wave TBZ500 Specifications

General IconGeneral
BrandEcolink
ModelZ-Wave TBZ500
CategoryThermostat
LanguageEnglish