Ecolink Z-Wave TBZ500 User Manual

Fan Mode indicators
System Mode indicators
TBZ500 24VAC OR BATTERY POWERED Z-WAVE THERMOSTAT
OPERATION INSTRUCTIONS
Backlight and Button Operation
The thermostat backlight is normally set to go out after 10
seconds of no button presses to conserve battery power. If
the backlight is off, the first button press of any button will
only turn on the backlight. Once the backlight is on, the
buttons function normally.
System Operation Modes
displayed = System is ON and heating.
If flashing, minimum run time (MRT) is active
displayed = System is ON and cooling.
If flashing, minimum run time (MRT) is active
Stage Indicators
• “1” = Stage 1 heating or cooling is ON
• “2” = Stage 2 heating or cooling is ON
• “3” = Stage 3 heating (Aux Heat) is ON
For Heat Pump systems only:
• “Heat-E” = Emergency heat mode active
Copyright © Ecolink Intelligent Technology
TBZ500_manual_8_5x5_5_inch Combined_RDN1240221.indd 19 24-02-2021 18:55
TBZ500 Display
19
Text Information Display Line
Low Battery indicator
Display Lock indicator
Z-Wave Network Installed indicator
Heating/Cooling Mode Selection
Button Mode Status
Backlit Display
Text Display Line
Temperature Setting Touch Buttons:
Warmer
Room Temperature
Cooler
Fan Mode Selection

Ecolink Z-Wave TBZ500 Specifications

General

Brand	Ecolink
Model	Z-Wave TBZ500
Category	Thermostat
Language	English