42
Using BIOS
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password has
been installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the
sub menu to change the supervisor password.
Supervisor Password
This page helps you install or change a password.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Supervisor Password
Install or Change the
password.
Help item
Supervisor Password :Not Installed
Change Supervisor Password Press Enter
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Default settings
F1:General Help
: Move
mnlk
Press <Esc> to return to the main menu setting page.
Load Default Settings
This option opens a dialog box to ask if you are sure to install optimized defaults
or not. You select [OK], and then press <Enter>, the Setup Utility loads all default
values; or select [Cancel], and then press <Enter>, the Setup Utility does not load
default values.
Press <Esc> to return to the main menu setting page.
NB Voltage Default (1.15v)
This item indicates the NB voltage default value.
SB V
oltage Default (1.20v)
This item indicates the SB voltage default value.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
