Chapter 3
H61H2-TI USER MANUAL
51
This page enables you to set setup administrator password and user password.
Security Menu
Administrator Password Status (Not Install)
This item shows administrator password installed or not.
User Password Status (Not Install)
This item shows user password installed or not.
System Mode state (Setup)
This item shows system mode setup or not.
Secure Boot state (Disabled)
This item allows you to enable or disable the secure boot state.
Secure Boot (Enabled)
This item is used to control the secure boot flow, it is possible only if system runs in
User Mode.
Main Advanced Chipset Frequency/Voltag Boot Security Exit
Set Administrator Password
Administrator Password Status Not Install
User Password Status Not Install
+/- : Change Opt.
Enter : Select
: Select Screen
: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC : Exit
Administrator Password
System Mode state Setup
Secure Boot state Disabled
Secure Boot Enabled
To Next Page
Loading...
Need help?
General
