Electrolux Professional S.p.A.
Ovens Platform Customer Support
Technical Training & Service
AOS OVENS - Service Manual
(595889300 – ENG)
Using the pressure inlet signed with “–” and with negative reading on the display as in the fig.31-32, this
means we are measuring + 0.16 hPa = + 16 Pa:
Using the pressure inlet signed with “
–” and with positive reading on the display as in the fig. 33-34, this
means we are measuring – 0.16 hPa = – 16 Pa:
Fig. 31 Fig. 32
Fig. 33 Fig. 34
14. Change of the microprocessor board
In case of changing of the microprocessor board, the following operations/calibrations have to be done:
1) Default parameter programming
2) Change parameters according parameter list
3) Lambda probe calibration for lev. A ovens (from firmware 2.6)
4) By-pass calibration (lev. B ovens) and cavity offset (parameter OCA1) or only cavity offset for lev. A
ovens.
File: AOS service manual (ENG).008 ©Copyright 2002 by Electrolux Professional P.18/40
To Next Page
Loading...
Need help?
General
