SOI/TD 2004-11 PR /26 599 36 44-44
26
16 QUICK GUIDE TO THE SPECIAL FUNCTIONS
The table below briefly describes how each of the special functions available to the user and to the Service Engineer can be used. To activate the user mode, the
selector must be turned clockwise; to activate the Service mode, the selector must be turned anti-clockwise.
Function Activation of the function Starting the function
Short description / Notes
Button
Selector position
Selector
and/or
Buttons
LED(s)
Level …... .. ..... ..... ..… ... L1 … … … ... L2 … … … … … ... L10
No of flashes End of cycle LED … 1 … … … … 2 … … … … … … 10
ex. level 3: 3 flashes, pause .… repeatable] x 1min.
USER (*)
Select
Regeneration
The cycle starts automatically signalling the various phases in progress with
the lighting of the relative LEDs.
Exit / Memorize
In order to memorize the functions or exit diagnostics mode, switch the appliance off turning the knob to On/Off position. In most cases the memorization or the
exit is automatic after 60 seconds (in this case the appliance goes to pre-selection mode).
(*) To activate the “user” functions no cycle has to be selected: to cancel them see 5.2.1; the appliance must be in pre-selection mode.
To Previous Page
Loading...
Need help?
General
