SOI/TD 2004-11 PR 26 599 36 44-44
5/
1 Purpose of this manual
The purpose of this manual is to provide service personnel (who already have the basic knowledge
necessary for repairing dishwashers) with information on dishwashers equipped with the EDW500
electronic control system, which are produced in the Solaro (MI - Italy) factory.
The EDW1500 control system consists of a main circuit board and a control/display board. Both
boards are housed in a single plastic container, with integrated selector. It is used in some “DIVA” models.
This Manual describes:
• General characteristics
• Control panel and programmes
• Technical characteristics
• Guide to diagnostics
For more detailed information regarding the hydraulic circuits and the structural characteristics of the
appliances, refer to the Service Manual for presentation of the “DIVA” structure (publication number
599 35 55–25 and 599 36 09-90).
2 PRECAUTIONS
Electrical appliances must be serviced only by qualified Service Engineers.
Always remove the plug from the power socket before touching internal
components.
3 GENERAL CHARACTERISTICS
Power supply ⇒ 230 V / 50 Hz (limits 187÷254 V)
Total power absorption ⇒ 2200 W (Resistance 2000W)
Mains water supply ⇒ Pressure Min. / Max. 5 ÷ 80 N/cm²
Capacity ⇒ 9/12 place settings (45/60 cm)
Consumption (prog. BIO):
Water ⇒ Lt. 14
Energy ⇒ KWh 0,8
Duration of cycle ⇒ 170’
Controls
- ON/OFF ⇒ On/Off function integrated to selector
- Programme start ⇒ By button Start/Reset
- Programme selection ⇒ By knob (n°3÷5 programmes)
- Option selection ⇒ By 1 button
- Display ⇒ Leds (On/Off, Start, cycle phases and alarms)
Washing system ⇒ Continuous (2600-2800 rpm)
Water fill level control ⇒ Pressure switch + Software
Water heating ⇒ Heating element enclosed in tube (2100 W)
Temperature control ⇒ NTC Temperature sensor
Drying systems ⇒ Activ
Safety systems / Alarms ⇒ Total protection (hydraulic + Software)
To Next Page
Loading...
Need help?
General
