DOC. NO. 5956.65J.00 P. 150 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
EUCAIGM - EUCAIDPJM - EUCAIDPJM
PROG 169
1. Switch OFF and then switch ON the machine.
2.
Enter into CFG parameter family and set the following parameters:
Hood Type and undercounter.
Atmospheric boiler.
Front loading function.
Default values for Undercounter models.
SOFT START enabled.
Tank heater works only if boiler temperature reached.
Enable filling tank by means of rinsing cycles.
Detergent level switches not enabled.
Select user interface hood type/ undercounter model.
Regeneration cycle disabled.
Alarms enabled.
Boiler electronic level sensor.
Resin regeneration cycle forcing.
Rinse water max. hardness.
Boiler heating control.
3. Switch OFF and then switch ON the machine.
4. Modify Factory parameters:
Enter into FAC parameter family and set the following parameters.
Boiler Temperature Threshold.
Boiler temperature: alarm threshold.
Boiler Temperature Adjust.
Boiler standby function enabled.
Booster Function.
During stand-by boiler is kept at lower temperature than Temperature Threshold.
Tub Temperature: Threshold.
Tub Temperature HISTERESIS.
Tank temperature: alarm threshold.
5. Modify the cycle parameters:
Cycle 1 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Cycle 2 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Cycle 3 parameters family.
Long Wash Phase [min].
Short Wash Phase [s].
Pause [s].
Rinse Phase Duration [s].
Drain [s].
Final Pause [s].
Boiler Temperature Threshold for Cycle 3.
To Next Page
Loading...
Need help?
General
