Electrolux EUC3DP/2 User Manual

DOC. NO. 5956.65J.00 P. 173 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
14 LIST OF PARAMETERS FOR SUBSEQUENT VERSIONS
The parameters listed below, even if present inside the software, cannot be used in appliances currently in
production.
Family
:
• parameter

•value 
Family 
Family  - alarm 
• parameter , the maximum value it can be set to is 3, but actually the only significant values are 0
and 1. By setting
 to 3, alarm F8 may appear, also implemented by the firmware, but not used in
any current application.

Water softener electronic board malfunction
Replace the water softener electronic board.

Salt water filling malfunction
(  up to
version 4.01)
The salt water container in the water softener was not completely filled within the
set max. filling time.
Make sure:
- the water cock is open
- the water filling solenoid valve works correctly
- the salt container solenoid valve works correctly
- the feed water pressure is at least 50 kPa / 0.5 bar
- the water inlet filter is clean
- the filling solenoid valve filter is clean
- the salt container cap is properly closed
- the mother board (ATM-PRES) connector CN2 is correctly positioned
- the water softener board connector ST5 is correctly positioned
- the grille on the bottom of the salt container is clogged with dirt.

Inefficient resin washing
After carrying out the maximum permissible number of resin washes, the resins are not suf-
ficiently cleaned by the salt water used to regenerate them.
Make sure:
- the water filling solenoid valve works correctly
- the feed water pressure is at least 50 kPa / 0.5 bar
- the water inlet filter is clean
- the filling solenoid valve filter is clean
- the mother board (ATM-PRES) connector CN2 is correctly positioned
.

Electrolux EUC3DP/2 Specifications

General

Brand	Electrolux
Model	EUC3DP/2
Category	Dishwasher
Language	English