P 2500 - P 500
14
4.1 Installation information for partly completed machinery
The partly completed machinery must not be put into service until the
final machinery into which it has to be incorporated has been declared
inconformity with the provisions of the machinery directive.
The safety functions of the controller comply with EN ISO 13849-1:2008 Kat.2
PLc.
DANGER!
Not-disengeable power supply
Risk of death by electric shock
According to EC Directive 2006/42/EG the mains supply
has to be equipped with an all-pole circuit breaker.
DANGER!
Danger through voltage!
Danger of an electric shock.
Only certified electricians should connect the barrier to
the mains supply.
CAUTION!
Danger of crushing and shearing!
With inadequate safety measures the movement of the
barrier boom can result in impact or crushing points
between the boom and solid objects within the movement
area.
According to DIN EN 12453, for an application with
pedestrian traffic, depending on the type of use and type
of activation, suitable safety devices have to be installed
additionally, in order to provide the minimum level of
protection.
Minimum clearances to solid objects must be observed.
4.2 Declaration of conformity
After the installation an EG-declaration of conformity according to EC-
machinery directive 2006/42/EG for the complete system has to be issued by
the person responsible for the integration (according to product standard DIN
EN 13241-1).
4.3 Name plate
The name plate of the barrier is attached at the inside front of the barrier
housing.
To Next Page
Loading...
Need help?
General
