Tinyhawk III Plus
1.3.4 Joystick Calibration
The E8 Transmitter (ELRS-2.4G) comes pre-calibrated, but recalibrating can help
resolve certain issues. With the E8 Transmitter (ELRS-2.4G) turned off,
simultaneously press the "L3-" button and the power button to turn it on. Wait
for the central indicator light to illuminate and transition from rapid flashing to
slow flashing. Move the joysticks of the E8 Transmitter (ELRS-2.4G) to their
maximum travel in all four directions (up, down, left, right). Press the "L3-"
button, a prompt sound will be heard, exiting calibration mode, and the E8
Transmitter (ELRS-2.4G) will boot up.
1.3.5 Left and Right Hand Switching
To switch between left and right hand modes, remove the screws and open the
back cover of the E8 Transmitter (ELRS-2.4G). On the left side of the board,
there is a toggle switch. Set the toggle switch to "L" (left-hand throttle mode) or
"R" (right-hand throttle mode), and swap the positions of the joysticks (the 6-
pin wires connecting the joysticks to the mainboard do not need to be changed).
In Left Hand Mode: Left joystick on the E8 Transmitter (2.4G) controls the
throttle and yaw direction of the Tinyhawk III Plus. The right joystick
controls the pitch and roll of the Tinyhawk III Plus.
In Right Hand Mode: Left joystick on the E8 Transmitter (2.4G) controls the
pitch and roll of the Tinyhawk III Plus. The right joystick controls the throttle
and yaw direction of the Tinyhawk III Plus.
To Next Page
Loading...
Need help?
General
