Emax Tinyhawk III Plus User Manual

emax-usa.com
Tinyhawk III Plus
11
1.3.6 Trainer Port & Simulator
Insert one end of a 3.5mm male-to-male cable into the trainer port (3.5mm
audio jack) and the other end into a simulator (sold separately) to output
corresponding channel values.
Insert a Type-C data cable into the remote controller to output corresponding
channel values.
1.3.7 Battery & Charging
The E8 Transmitter (ELRS-2.4G) is designed for a single 18650 battery with an
operating voltage range of 4.2V to 3.7V. When reinstalling the battery, slide the
battery compartment cover backward, install the battery with the correct polarity
(negative terminal on the side of the battery compartment with a spring), ensure
a perfect match between the battery compartment cover and the battery
compartment, push it forward until it locks. Incorrect battery installation will
prevent proper charging and startup.
To charge the remote controller, use the bottom Type-C port for charging. The
power charging indicator light's states are as follows:
 Steady red light: Charging in progress

Emax Tinyhawk III Plus Specifications

General

Brand	Emax
Model	Tinyhawk III Plus
Category	Drones
Language	English