Emerson AMS Wireless Vibration Monitor User Manual

Table 4-1: Field Communicator menu (continued)
Menu Submenu
Alert Setup Z Axis
X-Y Axis
Temperature
Battery
IB1-2 (Velocity)
IB3-4 (Accel)
Machine Conditions (PVP)
Note
Disconnect the leads when you are finished configuring or troubleshooting. The AMS
Wireless Vibration Monitor does not publish any new vibration data to the gateway while
connected to an AMS Trex Device Communicator or HART modem. It can take up to three
minutes for the leads connection to time out; after which, the AMS Wireless Vibration
Monitor resumes reporting new readings to the gateway.
4.4 Check device status
You can check the device status from the AMS Device Manager or the AMS Trex
Communicator.
The images below show the status of the device and what it means.
The device status is dependent upon individual device variable evaluation, system activity,
and operating parameters.
The out-of-the box overall status should always be Good.
The highest level severity is always be asserted, even if there are underlying lower level
alerts.
User Guide Operation
MHM-97927-PBF August 2020
MHM-97927-PBF, Rev 1 53

Emerson AMS Wireless Vibration Monitor Specifications

General

Brand	Emerson
Model	AMS Wireless Vibration Monitor
Category	Monitor
Language	English