[] Channel Selection
Selectchannelsbyusing[CH•/W] or[theNumberbuttons],
• To select the memorized channels,
use [CH • /V] or [the Number buttons].
• To select the non-memorized channels,
use [the Number buttons].
To Use [the Number buttons]
-When selecting analog channel 12
When selecting digital channel 12-1
Be sure to press l-lENT] before entering the minor
channel number.
-/ENT
• Press [CHANNEL RECALL] to return to the previously
viewed channel.
• When you select a channel larger than 100,
press [+100] first Then use [the Number buttons] to
press the lower 2-digit numbers.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
NTSC(analog mode) [AirTim, ATSC(digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
I__ l T I
major channel minor channel
,_ :change automatically
_> :change manually by using [CH A/T ]
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
•"NOSIGNAL"will appear on the TVscreen after the minor
channel broadcast is over.
[] Volume Adjustment
Thissectiondescribeshowto adjust the volume,Themutefunction,which
turnsthe soundoffandon,isalsodescribed,
Use [VOL • / ] to adjust the audio volume.
or
VOLUME 20
Illlll ..........
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear in
a few seconds.
Press [MUTE] to turn off and on the sound.
MUTE 20
Illlll ..........
• "MUTE" is displayed on the TV screen.
Press [MUTE] again or use [VOL • / ] to recover the
original volume.
EN