Emerson Fisher Multiport Flow Selector User Manual

Instruction Manual
D104239X012
Multiport Flow Selector
January 2019
33
User Setup Menus
To configure the actuator, select (highlight) the Device
Tag in the Navigation Pane per figure 12. Then Right
Click or use the Icon in the Menu Bar to select Detailed
Setup as shown in figure 13. The current Actuator
configuration and the default MPA settings or opened
Dataset settings are displayed. A Dataset is a file on
DCMLink based on the Device type and Displayed
Device Tag. A yellow Tab indicates there are
differences between the displayed Actuator
configuration and the displayed Dataset.
Configuration can be changed between the Actuator
and the Dataset and the actuator Configuration File
and Dataset can be saved to the PC. No passcode is
required to change User Configuration Settings
(Detailed Setup & Home Port Calibration) when using
DCMLink.
The Network Tab allows changes in configuration only
for the network ports. It does not affect the RDM port.
The Control Tab allows unused/unconnected Ports of
the MPFS to be bypassed. If a pipeline is not connected
to any one or more ports, or if it is desirable to skip any
one or more ports, click on the “Delete Port” number.
The deleted ports will be skipped when a next port
command is issued in either local or remote control
modes.
Notice: When configuration changes are made,
clicking the Blue arrows “Writes” the configuration to
the Actuator or Dataset. If there are no differnces
between the Actuator and Dataset, the arrows will be
grey. Using the dropdown box arrow of the Dataset
allows for parameter change selections to be made.
The “Read” button may be used to refresh the screen
to verify the parameters have been properly written for
storage in the actuator. You can read or write entire
configuration or just the opened page using the
Arrows or tab in upper right hand of the page. Values
are written to EEPROM when the Setup page or Device
Tag is closed. On the MPA LDM, within several seconds
of writing the configuration, the 3 LOR LEDs will
simultaneously flash slowly. This slow flash is a signal
that all new values were successfully written to
EEPROM.
Figure 12.
Figure 13.

Emerson Fisher Multiport Flow Selector Specifications

General

Brand	Emerson
Model	Fisher Multiport Flow Selector
Category	Control Unit
Language	English