Initial Setup
This section wili guide you through the unit's nital setting
which ndudes selecting a language for your on screen menu
and autoprogram, which automat tally scans and memorizes
v ewabie channels.
Before you begin:
Hake sure the unt is connected to antenna or cable.
1 After making all the necessary connections,
press _ to turn on the unit,
• It may take a few moments to turn on the unt for the
first time,
• [Initial Setup] menu appears automatcall7 after the
unt is turned on,
2 Use &/V to select the on screen language from the
choices (Engl sh / Espa_ol/Franca s) on the rght sde of the
]V screen, then press OK.
3 Use A/V to select [Antenna] forIV channels or [Cable]
for C/_IV channels, then press OK.
4
Use <1/1_ to select the desired location setting, then press
OK.
[Home] is ENERGY STAR _ qualified sett ng.
Select [Retail] s_tore,the unit will be set up with
predefined setting for retail d splays. In this setting, the
power consumption may possibly exceed the limited
requ rement of the ENERGY g IAR ® qualification.
Select [Home], the unit s set to maxmze the energ 7
efl]c ency for home setting and t can be adjusted
through a choice of picture and sound quality accord ng
to your preference. Use this setting to remove the
E St cker f vis ble fiom the display ,,_ p.23
When the nitial setup is completed, the lowest
memorized channel with the confirmation message of
the Iocat on sett ng will be d splayed on the ]V screen.
You must set [Home] in step 4. Otherwise, [Picture]
(
!zi!
ii !i!i
and [Sound] settings you adjusted will not be
memorized after the unt goes into standby mode.
• [Autoprogram] will begn.
Noe
If you are, not receiv ng a sgnal fl_m your cable serv ce, contact
the Cabe prov de_:
If you Dess (_ or MENU durng autoplsgram, ths setup of TV
channels w be canceed.
The init al autoprogram function can be exr,cuted fur ether
[Antenna] or [Cable] ony once.When you change the
connect on (Antenn / Cab e), set [Autoprogram] agan. ,,_- p.17
If them is no signa input fi-om the antenn terminal and no
operat on for several seconds after you turn or, the unit. he pful
hints appears. Follow the instruct ons isted on theTV screen.
After an initial setup is completed...
• If you want to scan the channels automatically again.
[Autoprogram] nlmi.p.17
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels] ,,_ p.18
• If you want to change to another language.
[Language] n,_ p.23
• If you want to change the location setting.
[Location] n,_ p.23
To Next Page
Loading...
Need help?
General
