6
i
Supplied Accessories
Owner's Manual Quick Start Guide Registration card
Remote Control
(NH001UD)
Batteries
(AAA, 1.SV x 2)
TV base and 3 screws (M4 x 14)
If you lose the screws, please purchase N4 x 14 Ph IIps head screws
at your Iota store,,
If you need to rep ace these accessor es, please refer to the part
name or No, with the lustlations and call our toll flee customer
support Ine foupd on the cover of this manual,
V_el sag a unve_sa _enoe coil _o o opelate d_s _s/:,
Nake sure the component code on your universa 1emote control
s set to our brand, Re@r to the mapua accompanying your
romote contro for more dora s.
We do not guarantee 100% nteroperability wth all universal
romote contro s,
Symbols Used in this Manual
The following s the descr ption for the symbols used n ths
manual. Description refers to:
:D gitallV operat on
:Analog/Cable rv operation
If neither symbol appears, the operation s applicable to
both.
Attaching the Base
You must attach the base to the unt to have it as a table top
unit, Be sure the front and rear of the base match the proper
direction, At least }_ people are requ red for these steps,
1 Check the text "FRONT" w_th "an ow" on the Base's
bosom to ensure t is being installed n the correct
direct on, Spread a thck and soft cloth over a table as shown
at step 2, Place the man unit face down onto it. Nake sure
not to damage the screen,
2 Insert 2 hooks under the
bottomofthemainunt _) .,. ,...
into base holes (shown by __ ....
arrow ,_)), then move the
base n the d rection as
shown by arrow (2) until
r_stops and the screw
holes are algned,
Make sure not to put the AC power cord between the
base and the unit.
Drve Ph Ilips head screws
into the 3 threaded holes
at the bottom of the base
until they are tght
[o _ , hove the base fort ds _r/t
• Unscrew the Phillips head screws in step 3,
After the screws are removed, pull the base up toward the rear of
the unit, Be ca1_'fu not to drop the base when you remove It,
Note
When attaching the base, ensure that all scl ews are tightly fastened,
If the base is not properly art ched, it could cause the unt to fal,
rr, sultin£ in injuries as well as damage to the unit,
Nake sure to use a tdble which can support the weight of this unit
and s larger than this unit,
Nal<e sure the table is in a stable location,
When attaching the base, ensure that"FRONT" wth "an-ow"
written on the bottom of the base is downwald, If it's not
downward, the _ hooks don't fit into the base,
Mounting the Unit onYour Furniture
Screw this unt on your furnture t ghtiy usng wood screw (not
supplied) in the hole at the back of the base as shown.
• Recommended screw dimens on :3/16 x 3/4 nches(5,1 x _0 ram)
rear of this unit
hole
To Next Page
Loading...
Need help?
General
