10
PREPARATION
Before you connect:
Be sure your antenna or other device s connected properly
Delore plu,_sng In the AC _ower cote1
Antenna Connection
_onnect the RF coaxial cable o ,our home outlet to the
_ntenna ingut 3ek of this unit
VHF/UHF
anal°8r _1_
DTV antenna " J
®
÷
÷
¢
®
@
®
RF coaxia CaD1e e
IIIIP,,,,,,,,,,,,,_ _°
?
cable TV signal
Once co_/tleciio_/s are cotRol(2tec1 turn on the unit and begin
inlt al setup. Channel scanning is necessary for the unit to
memorize all available channels in your area. [Initial Setup]
,, p.ll
No(,
If you have any quest on about the DTV's antenna, vsit
www.antennsweb.o% for further nformation,
Depending on your antenna system, you may need d tie, ant types
of comb nets (mixers) ol- separators (sp itters) for HDTV signa
the rain mum RF bandpass or, these devces is 2,000b1Hz Ol- 2GHz.
FoJ-you_-saft'ty nd to dvod damage to this unit, please unpu£ the
RF coaxa cable flsm the antenna input jack before movn£ the
unit,
If you did use an antenna to race ve anaog TV, t should aso
wod< for DTV receptor,. Outdoor or sttc ar,tennas w be more,
effect ve than a sot top or inside antenna,
lb switch your mcept on source easily br,tween antenna and cabe,
nstall an antenna selectoE
If you a_r, not mceiv n£ a sgna flsm your cable serv ca, contact the
Cabe prov de_:
Connection to Cable Receiver or
Satellite Box
Use an HDMI or ComponentV deo cables to connect the
HDMI or the ComponentV deo input jacks of the unit to the
HDPll or the ComponentV deo output jacks of the cable
race ver/satellite box.
if you connect to the unit's ComponentVideo input jacks,
connect Analog Audio cables to the Analog Audo L/R input
jacks right besde the ComponentVideo connector jacks.
satellite dis_
o}
cabl_TVsignal:
_,_ including PPV
I
, ....
: _ cable receiver/
_3_, ; ._. satellite box
! ! ?
comp ........ ide0 cable 4
i re a_dio cables
You can also connect this unit to the cable receiver or satellite
box other than the HDMI orthe ComponentVideo output jacks
or CompositeVideo output jack (n,_ p.26) because they mght
have different output jacks.
Requ red cables and connecting methods of the cable receiver/
satellite box, or the ava lability channel for the dear QAFfl may
dffer depend ng on the cable/satellite prov der or local iV
broadcas_Ler:
For more nformation, please contact your cable/satellite provider
or local IV broadcaste_
Noe
• Use an HDNI cabe with the HDNI logo (a ca/tiffed HDbll cable),
H£h Speed HDNI cable s recommer_ded for the better compat bi i%
Plug In theAC Power Cord
Nake sure that the AC power cord must be plugged to an AC
outlet after all the necessary connections are made.
C_ut o/:
Do not connect the AC power COld to a power supply outs de
the nd catr'd vo}tage ofths unit (AC 120V).
Connect ng the AC power cord to a power suppy outs de of this
range md 7 resut in fire or eectr ca shocks.
Note
Each time you pug n the AC power COlX),no operations wll be
pe_#ormed for a f_,w seconds.This is r_ot a real@net on,
To Next Page
Loading...
Need help?
General
