ENEN
10
4. FIRST START-UP
It must be selected then press the icon
The factory configuration includes the MIRAI-SMI 4.0 HP and the
Febos-Energy, while no Febos-Crono Slave is available.
On the System Map the configured devices are represented with
a green background, those not configured on a grey background.
Press the respective icon to change its status, then OK.
The configuration of the Modbus network must be carried out on
the Febos-Crono Master.
Access the settings by pressing the
Mirai-SMI 4.0
Febos-Energy
Febos-Crono Slave
(indirizzi 11÷19)
Press OK again to confirm the changes.
4.1 WiFi connection
(Febos-Crono WiFi model)
Verify that date and time are aligned otherwise set them as de-
scribed in paragraph 6.3.5.
4.2 System Map Configuration
(Modbus network)
ATTENTION
When the Febos-Crono is powered up for the first time, it is
necessary to wait a few minutes before the display comes on.
Furthermore, a period of time of at least 1 hour of inactivity
(active screensaver) is required before the temperature and
humidity sensors go to full capacity and measure the ambient
values correctly.
For the following procedures, log on as Service
ATTENTION
At the first power supply of the Febos-Crono you need to wait
a few minutes before turning on the display.
Also you need to perform in sequence the following steps:
SERVICE
Mirai-SMI 4.0
Febos-Energy
Febos-Crono Slave
(indirizzi 11÷19)
To Next Page
Loading...
Need help?
General
