Page 2 www.enersys.com Publication No. US-RE-IOM-002 January 2012
1.1.2 Range Summary
The range is available in single cell (2 Volt) units or 6 cell (12 Volt) units. All cells feature bolt-on
connections at all terminals for ease of installation.
The single cell units (1RE range) feature a rugged plastic container featuring lift handles. Sizes
range from 207 Ah up to 2208 Ah at the 20 hour rate. They are ideal for remote locations where
lifting equipment is not available for installation. The plastic container also reduces maintenance
by helping mitigate ground shorts due to electrolyte spills. Any concern with container corrosion
is also removed. The cells can be installed on any acceptable floor or on customer supplied
racks.
The 6 cell units feature acid resistant epoxy-coated steel trays with lifting holes and mounting
flanges to bolt the batteries to the floor or into a rack. Sizes range from 384 Ah up to 2208 Ah at
the 20 hour rate. The 6 cell units are ideal for industrial applications where speed of installation
and modular design is a high priority. Lifting can be done with an overhead crane using specially
designed lifting straps available from EnerSys
®
. All intercell connections are made with welded
lead connectors so only terminal connections must be made. Terminal connections of each unit
are bolt-on, allowing easy cabling to the next unit or the DC bus.
WARNING
The RE series is intended for nominal system voltages up to 48 Volts.
Exceeding this voltage is not recommended and can be extremely
hazardous. Contact your sales representive to inquire about custom
designed batteries for high voltage applications.
6
CELL (6RE)
Figure 1.2
SINGLE CELL (1RE)
Figure 1.1
To Next Page
Loading...
Need help?
General
