Epilog Laser Fusion Pro 32 User Manual

Setting Up CorelDRAW for the Laser
If you are using CorelDRAW, first make this quick, one time change to the settings.
1. Go to Tools > Options > Global > Printing > Driver Compatibility.
2. Select Epilog Engraver from the drop-down list.
3. Select “Printer can match document page sizes”, and click OK. You’re ready to go!
Note: If you cannot check this box, see “Troubleshooting the Laser Dashboard” on page 88.
- 56 -
SECTION 5: THE LASER DASHBOARD

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English