Light status Condition/solution
Ink level may be low. It is nearly time to reset the ink levels by refilling
The power light is on or
the ink. You can continue printing, but you should prepare new ink
flashing
bottles. To confirm the actual ink remaining, visually check the ink levels
The ink light is flashing
in the product's ink tanks.
Ink level may have reached the lower line of the ink tank and it is time to
The power light is on or
reset the ink levels. To reset the ink levels, refill the ink.
flashing
The ink light is on
Caution: Continued use of the product when the ink level is below the
lower line on the ink tank could damage the product.
The ink pads are near the end of their service life. Contact Epson for
The power light is on or
flashing
support. (To continue printing, press the B&W copy button or the
color copy button.)
The ink light is flashing
The paper light is flashing
An error has occurred during firmware updating. Connect your product
The ink light is on
using a USB cable and try updating the firmware again. If the error
The paper light is on
message continues, contact Epson for support.
A fatal error has occurred. Turn the product off and then back on again.
The power light is flashing
If the error continues, check for a paper jam. If the error persists,
The ink light is flashing
contact Epson for support.
The paper light is flashing
Parent topic: Solving Problems
Related references
Paper Jam Problems
Where to Get Help
Related tasks
Refilling the Ink Tanks
Related topics
Loading Paper
Running a Product Check
Running a product check helps you determine if your product is operating properly.
141
To Next Page
Loading...
Need help?
General
