Fine-Tuning the Projector 53
10. To enable your screen logo, select User’s Logo Protect and press
Enter. Select On and press Enter.
When this feature is on, the logo appears whenever you turn on
the projector (if the
Startup Screen is enabled in the Extended
menu; see page 54). It also appears when you press the A/V Mute
button (if you selected the
Logo for the A/V Mute setting under
Display in the Extended menu). None of the User’s Logo features
in the Extended menu can be changed when the User’s Logo
Protect function is enabled.
Starting the Projector with a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the
Num button on the remote control and use the
numeric keypad to enter the four digit password.
The password screen closes, the numeric keypad is automatically
deactivated, and projection begins.
If the password is not correct, you see a message prompting you to
re-enter the password. If you enter an incorrect password three times
in succession, you see the message
The projector’s operation will be
locked. Request code xxxxx
and the projector switches to standby
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector’s power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
To Next Page
Loading...
Need help?
General