General Settings - Network Settings
*Default setting
Settings item Settings value Explanation
Wi-Fi Setup
Router (Connect via Wi-Fi)
Disconnected or disabled
This is displayed in gray. Touch this, and on the next screen
touching Start Setup will display a Wi-Fi Setup Wizard menu,
performing a connection operation.
Connected
Touch to display the connection status and settings information.
Touch Change Settings to display Wi-Fi Setup Wizard and other
menus that allow you to switch the access point.
U “Switching to Wireless LAN” on page 94
Wi-Fi Setup Wizard The list of SSIDs for the detected access points is displayed. From
the list, select the SSID to connect to, and connect.
Push Button Setup(WPS) If the access point to use supports WPS (Wi-Fi Protected Setup),
then this menu item can be used for connection. Input of SSID and
password is not required. After selecting this menu item, touch and
hold the push button on the access point until it flashes, then again
touch Start Setup on the printer screen to connect.
Others
PIN Code Setup(WPS) If the access point to use supports WPS (Wi-Fi Protected Setup),
then this menu item can be used for connection. Touch this to
display the PIN code and Start Setup. Input the displayed PIN code
from a computer into the access point within 2 minutes, then touch
Start Setup to connect.
Wi-Fi Auto Connect The menu used after installing software from the Software Disc, and
connecting to the printer by following the wizard.
Disable Wi-Fi Selecting this means that the wireless LAN connection will be
initialized and disconnected. In the event of problems with the
wireless LAN connection, use this menu to reconnect and attempt
to resolve the problem.
SC-T3100M Series/SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series/SC-T2100 Series User's Guide
Using the Menu
150
To Next Page
Loading...
Need help?
General