5 6
TM-U220A
Specification
(For Argentina Fiscal)
1.6 Takeup Device
A takeup device automatically takes the roll paper up in connection with a paper feed motor.
1.7 Autocutter
1) Cutting method By separated-blade scissors
2) Cutting type Partial cut (one point in right edge left uncut) by factory setting
Full cut (complete cut-off) is also possible by dealer setting
(Change the cutting type by moving the position of the autocutter unit.)
NOTES: 1. 2.116 mm or more of paper feed after cutting is recommended before printing to prevent
dot displacement.
2. Switching between partial cut and full cut is not controlled by a software command.
3. The cutting type (partial cut or full cut) must be selected before the printer is first used.
If the cutting type is changed after the printer has been used, the printer may not be
reliable because the wear-out level of the cutter blade differs between partial cut and full
cut.
<Prohibited matters>
• When the paper is cut completely (full cut), make sure to remove the cut paper, then perform the
next cut. Never leave several pieces of the cut paper in the paper exit, or the cut paper may fall
into the paper path, causing possible double cutting, paper jams, or autocutter errors.
To Next Page
Loading...
Need help?
General