Note: When a connection is established, the input source for the projector automatically switches to the
LAN source if no other signal is being input. If the input source does not automatically switch to the LAN
source, press the LAN button.
Parent topic: Connection Methods
Related tasks
Setting Up a Projector to Connect in Quick Connection Mode
Searching for Network Projectors Automatically
Searching for Network Projectors by Specifying an SSID, IP Address, or Projector Name
Performing a Profile Search
Connecting the Projector and a Computer over a Network System (Wireless)
When your projector is set up as indicated below, you can connect the projector to an existing network
system and project the computer's screen over the network.
• The wireless LAN unit is installed in the projector.
• The projector's connection method is set to Advanced.
Note: Make sure you connect a computer to the network.
1. Press the LAN button on the remote control.
The LAN standby screen is projected.
26