Epygi QX200 User Manual

Configuring QX IP PBXs with Flowroute
Revision 1.0 4 26-Sep-16
1 Introduction
This document describes how to configure the Epygi QX IP PBXs (herein IP PBXs) to use the VoIP SIP trunking
service from Flowroute. The IP PBX is capable of making IP-PSTN calls via Flowroute SIP trunks. This solution
allows IP PBX users to make cost saving calls to the global PSTN.
Please Note:
• The described configuration is generic for all Epygi QX IP PBX models, such as the
QX50/QX200/QX2000/QXISDN4+.
• Security issues and calling rates are beyond the scope of this document. See the listed documents in
References section to get more information on the security related issues.
2 Scenario
Provider: Flowroute SIP Trunks
• offers outbound and inbound calls
• allows parallel outbound calls to be made from one account
• allows parallel calls to be received on one account
Customer:
• The customer will be making long distance cost saving PSTN calls through the Flowroute SIP trunks.
2.1 Requirements and Preparations
• The IP PBX is connected to the network and all network settings are properly configured.
• The IP PBX is running software version 6.1.x or higher.
2.2 Account Information from Flowroute
Flowroute will provide the customer with the following data (all data used below are just samples):
• Username – 49135259
• Password – ************
• SIP Registrar – sip.flowroute.com
• Signaling port for SIP Registrar – 5060
• Telephone number(s) (DIDs allocated to the customer) – 12012994794, 12015354360

Epygi QX200 Specifications

General

Brand	Epygi
Model	QX200
Category	Network Hardware
Language	English