Escort MAX Ci 360 User Manual

13
Settings & Preferences
Marker Enables
In the factory default setting, the suggested xed
location alerts are reported. It is highly
recommended that you use your ESCORT MAX Ci
360 in this mode.
If you modify Marker Enables then this setting will
show Modied and only the Markers that you have
selected are reported.
Marking Locations
The MRK button allows you to mark a specic
location and label it for future reference. Once
marked, ESCORT MAX Ci 360 will provide an alert
when you reach this area again.
ESCORT MAX Ci 360 gives an advanced warning of
upcoming markers at the following distances:
• Red light cameras: 250 ft or 10 seconds
• Red light & speed cameras: 250 ft or 10 seconds
• Speed cameras: 500 ft when traveling below 55
mph; 1,000 ft when traveling above 55 mph
• Speed traps: 0.3 mi or approximately 1,584 ft
• Other: 500 ft when traveling below 55 mph; 1,000
ft when traveling above 55 mph
Red light camera
Red light &
speed camera
Speed camera
Speed trap
Other
To mark a location, press the MRK button. The
display will read “Mark?” Press MRK again to bring
up a menu of markers to choose from.
Repeatedly press MUTE to scroll through the
markers then press MRK to select the marker that
you wish to use at this location. The display will
read “Marked!”
Air Patrol locations cannot be marked by the user.
Note: When a location is marked the rst time, you
must travel at least 1 mile away from that location to
receive an alert when you return to the area.
To unmark a location, touch the MRK button when
you are receiving a marked-location alert. The
display will read “Unmark?” Touch the MRK button
again to conrm. The display will read “Unmarked!”
Clear Locations
At some point, you may wish to clear some of the
data in ESCORT MAX Ci 360’s database. This may
include any of the following: Defender Database
data, Marked locations or false alert Lockouts. To
clear all data in ESCORT MAX Ci 360’s database.
select Format then press MUTE to conrm .
Restore factory Settings
To restore ESCORT MAX Ci 360 to it’s original
factory settings, press and hold MRK and BRT
while turning the power on. A Restored message
will display, acknowledging the reset.
Serial Number and Software Version
To view your ESCORT MAX Ci 360’s serial number
and software revision, press and hold the MRK and
SEN buttons while powering on the detector.

Escort MAX Ci 360 Specifications

General

Brand	Escort
Model	MAX Ci 360
Category	Radar
Language	English