Escort MAX Ci 360 User Manual

20
Problem
Detector beeps briey at the same
location every day, but no radar source
is in sight.
Detector did not alert when a police
car was in view.
Detector’s audible alerts become
softer after the rst few alerts.
The power-on sequence reoccurs
while you are driving.
You wish to restore the factory default
settings.
The device will not turn on.
The display is blank.
Detector displays “Check FR”
Detector displays “Replace RR”
Solution
A motion sensor or intrusion alarm is located within range of your
route. If you have AutoLearn enabled, the factory default setting,
then ESCORT MAX Ci 360 will store this signal after about 3 passes
and no longer alert to it.
Ocer may not have radar or laser unit turned on.
VASCAR (Visual Average Speed Computer and Recorder), a
stopwatch method of speed detection, may be in use.
Detector is in AutoMute mode. See “AutoMute” in the Settings &
Preferences section for details.
A loose power connection can cause ESCORT MAX Ci 360 to be
briey disconnected and will retrigger the power-on sequence.
Check all connections.
Press and hold the MRK and BRT buttons while powering on the
detector. A “Factory Settings Restored” message will display,
acknowledging the reset.
Check that vehicle ignition is on.
ESCORT MAX Ci 360 is in Dark mode. Press the BRT button to
adjust the brightness.
There is a communication issue with the Front Receiver (FR). The
Front Receiver’s connections and wiring should be checked. If no
connection or wiring issue is found and the message persists
there may be an issue with the component.
A critical issue has been reported from the Rear Receiver (RR)
requiring it to be replaced or repaired.
Troubleshooting Service Procedure

Escort MAX Ci 360 Specifications

General

Brand	Escort
Model	MAX Ci 360
Category	Radar
Language	English