-
+
-
+
-
+
English
18 EN
Counters are displayed by pressing the (27) key.
The following message appears on the display (14):
Parameters calculated are:
- N. coffee (number of coffee beverages)
- N. water (number of times water is dispensed)
- N. steam (number of times steam is dispensed using
the steam button)
- N. steam TS (number of times steam is dispensed using
the turbosteam function)
- N. steam + air TS (number of times steam and air are
dispensed using the turbosteam function)
- N. tot coffee (total number of coffee beverages).
Counters can be zeroed by aligning the cursor on the
selected entry, pressing the
“PRG” key (29), and then
pressing the
“+” (30) or “-” (31) key.
Press the
“RES” key (24) to con¿rm zeroing.
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the
“RES” key (24) to return to the main menu.
À COUNTERS MENU
N° coffee gr. 1 01234
19. DATA menu - Counter display and zeroing
NOTE. ONLY if the item “Customer Progr.” is
set on “YES" and the item “Program. block” is
set on “NO".
To access programming press the
“PRG” (29) key; the
following message will appear on the display:
Press one of the dispensing keys on the selection panel;
the relative led will remain on.
20. How to access the programming mode
Use the “+” (30) or “-” (31) keys to position the cursor
on the desired line, then press the
“PRG” (29) key.
Always use the
“+” (30) and “-” (31) keys to change
the setting; at this point there are two possibilities:
1) con¿rm the changes made by pressing the
OK
key
2) exit the menu and leave the settings unchanged by
pressing the
“RES” (24) key.
Note: When modifying data, the cursor changes to "Æ", or a
slide bar with maximum and minimum settings will appear:
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
À CUSTOMER PROG.
KEY MENU
02_EmblemaR_1442.indd 18 21/10/2014 09:41:34
To Next Page
Loading...
Need help?
General
