Faema Emblema R User Manual

2
12
5
7 8 9
1 3
1110
6
13
14 1615
4
English
25 EN
Remove the filter holder
from the coffee group.
Using a brush, clean the
cover gasket.
Hold down the coffee circuit
washing key
(26) for a few
seconds.
The simultaneous washing
screen (preset mode) will
appear on the display.
to change sel.
to con¿rm
to change sel.
to con¿rm
to change sel.
to con¿rm
INSERT. FILTER
HOLDER
GROUP 3
push
to confirm
Insert the rubber disk into
the ¿lter-holder with its ¿lter.
Pour in a packet or dosing
cupful of detergent powder.
Hook the filter holder to
Group 3.
Press the coffee circuit wash
key
(26).
Press the coffee circuit wash
key
(26).
GR3 WASH
The Group 3 wash cycle will
start and the "GR WASH"
message will appear on the
display.
At the end of the group 3
wash cycle, the message
"REMOVE FILTER HOLDER
GROUP " will appear.
REMOVE FILTER
HOLDER
GROUP 3
push
to confirm
GR3 RINSE
The message "GR RINSE"
will appear.
Remove the ¿lter holder.
Repeat these steps for the
groups you want to wash.
The washing cycle is
complete after the rinsing
phase.
Do not remove the ¿lter holder
during coffee dispensing.
Use the
“+” (30) and “-” (31) keys to pass to the SinJle
Wash. An arrow will highlight the group that will be washed.
Use the “+” (30) and “-” (31) keys to choose the group
to be washed.
Confirm the choice (for
example, group 3), using
the key and
OK
. The screen
will display:
SINGLE WASHING: Cannot be carried out if the machine launches a warning message.
02_EmblemaR_1442.indd 25 21/10/2014 09:41:48

Faema Emblema R Specifications

General

Brand	Faema
Model	Emblema R
Category	Coffee Maker
Language	English