1 32
4 5
A
10
13c
13c
English
26 EN
Block function
When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested
wash cycle is pressed (key
26) or key (28)) and the
instructions on the display are followed, the wash cycle is
performed and the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
If the coffee wash circuit key
( 26) is pressed, the previous
message will be integrated as shown:
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in
alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
GROUP 1 LOCKED
EXECUTE WASHING
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
GROUP 1
Put a liter of cold water in a
suitable container and add
detergent.
Remove the ¿lters from the ¿lter-holders.
Soak the filters and the
¿lter-holders in this solution
for about 15 minutes.
Place the ¿lters back in the ¿lter holder, making sure that
the anchoring spring (A) of the ¿lter is in its slot.
FILTER-HOLDERS - 7KLVRSHUDWLRQPXVWEHPDGHRQDOOWKH¿OWHUKROGHUVDWWKHHQGRIHDFKZRUNLQJGD\
Remove any residue with a sponge and rinse well with
cold water.
Keep a hot water distributor key (13a - 13c) pressed down
for approximately 5 seconds.
The following message will be displayed: “WATER
CHANGE”. The water from the boiler will drain from the
hot water nozzle (
10) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
functions and the boiler will be re¿lled with fresch water.
CHANGING THE WATER IN THE BOILER - Procedure to carry out at least once a day
02_EmblemaR_1442.indd 26 21/10/2014 09:41:50
To Next Page
Loading...
Need help?
General
