To Next Page

To Previous Page

Document #: XE-SNB1-Install-PM-R0A

p. 13

inView 360 Fusion Installation Guide

Installing Video Components

Connecting the Monitor

Once the monitor is mounted in position, you'll need to connect its harness to power, then connect it to the ECU's

video harness� To do this:

1� Connect the black wire to an appropriate ground source�

2� Connect the yellow and red wires to the vehicle's ignition source�

3� Connect the AV1 cable (with yellow connector) to the AV adapter�

4� Connect the video (yellow) connector of the AV adapter to the CVBS connector on the ECU video harness (via

extension cable)�

GND

IGN

AV Adapter

Video

Harness

Video extension

cable

Questions and Answers:

Need help?

Do you have a question about the FRC inView 360 Fusion and is the answer not in the manual?

FRC inView 360 Fusion Specifications

General