FRC inView 360 Fusion User Manual

© Safe Fleet | September 2018 | All rights reserved
Document #: XE-SNB1-Install-PM-R0A
p. 3
inView 360 Fusion Installation Guide
Introduction
Introduction
This guide describes how to install and use the inView 360-Fusion Around Vehicle Monitoring (AVM) system� inView
360-Fusion provides drivers with a real-time, 360-degree picture of the area around their vehicle to eliminate blind spots,
help improve pedestrian safety, prevent vehicle damage, and avoid liability costs�
Installation Principles
Installation of the inView 360 Around Vehicle Monitoring system is for certied personnel only. For more information on
the certication process, please contact the FRC Service Team (please see the back of this guide for details).
The installation process involves drilling into the exterior of a vehicle to mount cameras� Ensure you read this document
carefully, and verify the correct mounting locations prior to drilling�
System Components
The inView 360-Fusion installation package contains the following components:
1x ECU (Electronic Control Unit)
1x ECU Mounting
Bracket w/ 4x Screws
Electronic Control Unit (ECU) Components
NOTE: The installed system will not operate correctly until it has been calibrated. For more information,
see the inView 360 Calibration Guide included in the Calibration Kit.

FRC inView 360 Fusion Specifications

General

Brand	FRC
Model	inView 360 Fusion
Category	Automobile Electronics
Language	English