Output Format
149
Copy
3
îš„Z Fold Half Sheet
The machine folds the output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17".
If you have mixed sized documents, the width (vertical direction) of the paper must be
the same, such as a combination of A4 (portrait) and A3 (landscape), and a
combination of B5 (portrait) and B4 (landscape). For example, if you have a
combination of A4 (portrait) and A3 (landscape), the Z fold is only applied to A3.
îš„Output Destination/Offset
Allows you to select the output destination tray and offset operation.
z
Offset Stacking
This option is displayed if you select [Right Middle Tray] for the output destination.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations.
You can specify by set, job, specified number of pages, or specified number of
copies for a paper stack.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
Paper Size and Stapling Position
z
Finisher C2/Finisher C2 with Booklet Maker
* : The staple orientation displayed on the touch screen differs from the actual staple orientation. Outputs are stapled
in the orientation shown in the above table.
z
Finisher D2-P with Booklet Maker
1 Staple
1 Top
Right
2 Staples 2 Top 2 Right
A4 , B5 ,
8 x 10" ,
8.5 x 11" ,
16K
A4, 8 x 10",
8.5 x 11",
8.5 x 13",
8.5 x 14"
A3, B4,
11 x 17", 8K
1 Staple
1 Top
Right
2 Staples 2 Top 2 Right
A4
B5 , 8 x 10" ,
8.5 x 11" ,
16K
*
*
* *
To Next Page
Loading...
Need help?
General
