Fuji Xerox DocuCentre-IV C5570 User Manual

Fax Procedure
167
Fax
4
For information on how to fax mixed sized documents, refer to "Mixed Size Originals (Scanning
Different Size Documents Simultaneously)" (P.210).
1 Remove any paper clips and staples before
loading a document.
2 Adjust the document guides to match the
size of the document loaded.
Note • When loading a large size document such
as A3, lift up the document feeder tray,
and open the document stopper
rightward.
3 Load the document (the front side of 2-sided
document) face up in the center of the
document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly.
• When the document is loaded in the
document feeder, the document feeder
tray lifts up. You can set the timing of the
lift. For more information, refer to "5
Tools" > "Common Service Settings" >
"Other Settings" > "Document Feeder
Tray Elevation" in the Administrator Guide.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
1 Open the document cover.
Important • Ensure that the touch screen is active,
and then load a document. Otherwise, the
machine may not properly detect the
document size.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
Document stopper
Confirmation indicator

Fuji Xerox DocuCentre-IV C5570 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV C5570
Category	All in One Printer
Language	English