3 Maintenance
100
Maintenance
3
Important • Do not touch the ink pad of the stamp cartridge. If it comes into contact with your skin, wash
immediately.
• Problems caused by using consumables not recommended by Fuji Xerox are not covered by the
maintenance service contract.
• Before using consumables, carefully read instructions and precautions on their packages.
Note • We recommend always keeping spare consumables/periodic replacement parts in stock.
• To order consumables, contact our Customer Support Center.
(Product Name: Stamp Replacement Kit, Product Code: F451)
1 Pull up the knob on the document feeder top
cover, and open the document feeder top cover
completely.
2 Pull up the lever to open the inner cover.
3 Stick the supplied pin into the old stamp
cartridge, and pull it straight out of the
machine.
Note • If only the sponge part of the stamp
cartridge is removed, make sure of removing
the bottom part of the cartridge.
4 Insert the new stamp cartridge.
5 Close the inner cover of the document feeder.
6 Close the left cover of the document feeder until it clicks into place, and confirm that there
is no space between the near or far side of the cover and the document feeder.
To Next Page
Loading...
Need help?
General
