16 Appendix
660
Appendix
16
9 Select [Name], and select [Change Settings].
10 Enter the type name, and then select [Save].
Note • We recommend you to use a name such as "Single Fold Plain" that allows you to know what the
content is.
11 Select the fold type, and then select [Change Settings].
For details on making each fold adjustment, refer to the following sections.
- For single fold, refer to "Single Fold Position Adjustment" (P.660).
- For booklet, refer to "Booklet Position Adjustment" (P.661).
- For C fold, refer to "C Fold Position Adjustment" (P.663).
- For Z fold, refer to "Z Fold Position Adjustment" (P.664).
- For Z fold half sheet, refer to "Z Fold Half Sheet Position Adjustment" (P.665).
Single Fold Position Adjustment
Adjust the single fold position.
1 Select [Single Fold], and then select [Change
Settings].
2 Specify [Sheets to be folded], and then select
[Sample Printout].
3 Select the tray in which you loaded paper, and
press the <Start> button.
The sample is printed.
4 Select [Close].
5 Check the sample printout, measuring the misaligned amounts.
To Next Page
Loading...
Need help?
General
