HP-GL/2 Emulation
699
Appendix
16
Restriction on Auto Layout
When the extra Hard Disk is installed on the printer
When Auto Layout is enabled, the print data is stored to the hard disk.
When the extra Hard Disk is not installed on the printer
When Auto Layout is enabled, the print data is stored to auto layout memory area.
The default size of auto layout memory is set to 100kbyte and an error will occur on the
printer when the print data exceeds 100kbyte. In this case, change the size of auto layout
memory using the control panel. Auto layout memory size can be set up to 5120kbyte. The
printer cannot receive the print data exceeding 5120kbyte.
We recommend you to install hard disk on the printer when using Auto Layout feature.
Paper Margin
The paper size is set to A series paper by factory default. If the print data is larger than the
active coordinates area, the machine prints the data on the next larger A series paper (for
example, the next larger size of A4 is A3).
When you set the paper margins, however, the active coordinates area is determined by
subtracting the area set in paper margins from the active coordinates area obtained in the
area determination mode. Therefore, set the paper margins if the data is printed on larger
paper than specified. Set the range from 0 to 99 mm. The default value is 0 mm.
HP-GL/2 Emulation Settings
The following table shows the emulation parameters and their values for HP-GL/2
emulation.
HP-GL/2 Settings List
Items that can be set using the HP-GL/2 mode menu are explained in two groups: basic
settings and extended settings.
To Next Page
Loading...
Need help?
General
