Replacing Consumables
89
Maintenance
3
13 Slowly slide out the cleaning bar housed within
the LED printhead until it stops. The cleaning
bars are located in the cleaning connection just
under the drum cartridges R1, R2, R3, and R4.
Important • Do not remove the cleaning bar from the
housing.
Note • Slide out the cleaning bar until you see
"".
14 Slowly slide the cleaning bar back into place.
Note • Clean the four LED printheads R1 to R4 by
sliding the cleaning bar back and forth for
two or three times respectively.
15 Return the cover to the original position.
Note • Push the cover until it clicks into place.
16 Rotate the release lever clockwise to lock the
cover.
17 Close the front cover.
Note • If the front cover is not closed completely, a message appears and the machine will remain paused.
Replacing Staple Cartridge (for Finisher-A1)
When the Finisher-A1 (optional) is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use only staple cartridges recommended by Fuji Xerox.
Note • To order a staple cartridge, contact our Customer Support Center.
To Next Page
Loading...
Need help?
General
