Fuji Xerox DocuCentre-V C4475 User Manual

5 Tools
218
Tools
5
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Note • [Added Port Number] cannot be configured if [Port Status] is set to [Disabled].
To configure [Added Port Number], enable port status and reboot the machine, and then configure
[Added Port Number].
Bonjour
 Port Status
Select [Enabled] to use Bonjour
®
.
Note • To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
Port 9100
 Port Status
Select [Enabled] to use Port9100
®
.
Select this option when the communication protocol is in the RAW format for Windows
Standard TCP/IP port monitor.
 Port Number
Enter a port number for Port9100 from 1 to 65535.
The default value is 9100.
Important • Do not use the numbers assigned to the other ports.
SNMP
 Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
SIP
 Port Status
Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.
 Port Number
Enter a port number to use IP fax (SIP).
The default value is 5060.
Important • Do not use any numbers assigned to other ports.
Note • IP fax (SIP) is not available for some models.
FTP Client
 Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive Mode] and [Active
Mode]. [Passive Mode] is selected by factory default. You can change the setting from CentreWare
Internet Services.

Fuji Xerox DocuCentre-V C4475 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-V C4475
Category	Printer
Language	English